| Step | | Procedure & Parts & Tools |
| 1 |
|
REMOVE THE POWER CORD FROM THE CORD HOOK.
|
| 2 |
|
UNHOOK THE VAC HOSE FROM THE HOSE HOOK.
|
| 3 |
|
SLIDE UP ON THE BAG COVER LATCH. PULL THE BAG COVER FROM THE MACHINE.
|
| 4 |
|
PUSH IN ON THE RED LEVER ON THE RIGHT SIDE TO UNLOCK THE BAG.
|
| 5 |
|
PULL THE BAG DOWN OFF THE INTAKE HOSE.
|
| 6 |
|
REMOVE THE 4 SCREWS HOLDING THE UPPER VAC HOUSING.
| Screwdriver-phillips |
|
|
| 7 |
|
PULL THE UPPER VAC HOUSING UP TO SEPARATE IT FROM THE LOWER VAC HOUSING.
|
| 8 |
|
LOOSEN THE 2 SCREWS HOLDING THE GUIDE HOUSING.
| Screwdriver-phillips |
|
|
| 9 |
|
PULL UP ON THE TOP OF THE UPPER VAC HOUSING TO SEPARATE IT FROM THE LOWER VAC HOUSING.
|
| 10 |
|
LOCATE THE BASE PLUG ON THE BOTTOM OF THE MIDDLE VAC HOUSING. NOTE: THE 3 PRONGS ARE LABELED IN THE PIC SHOWN HERE. PLACE 1 LEAD ON THE FIRST PRONG (GREEN/YELLOW WIRE).
| Volt meter (True RMS capable) |
&Width=100)
|
|
| 11 |
|
INSERT THE OTHER LEAD INTO THE TERMINAL BLOCK OF THE CORRESPONDING WIRE (GREEN/YELLOW WIRE). SET THE VOLT METER TO CONTINUITY. IF THE VOLT METER BEEPS, THE WIRE IS OKAY. REPEAT STEPS 10 AND 11 FOR THE 2 BLUE WIRES.
| Volt meter (True RMS capable) |
|
|